tag:blogger.com,1999:blog-5854741938955568545.post8363015763185013446..comments2024-03-26T01:53:19.600-07:00Comments on ElectricRCAircraftGuy.com--RC, Arduino, Programming, & Electronics: Beginner RC Airplane Setup - Person 1 - Response 1Gabriel Stapleshttp://www.blogger.com/profile/10071071884455787806noreply@blogger.comBlogger3125tag:blogger.com,1999:blog-5854741938955568545.post-30401935402639459522013-05-06T23:42:56.863-07:002013-05-06T23:42:56.863-07:00Thanks for taking time for sharing this article, i...Thanks for taking time for sharing this article, its very informative especially for a newbie, I just bought my first <a href="http://www.nitrotek.it/aerei-rc.html" rel="nofollow">Rc plane</a> and this information is really useful for me, Thanks, you didn't wander to un-important subjects and kept the interest up.<br /><br />Regards,<br />Barry MartinAnonymoushttps://www.blogger.com/profile/02598183548370856932noreply@blogger.comtag:blogger.com,1999:blog-5854741938955568545.post-49138059360591670482013-03-16T20:31:28.639-07:002013-03-16T20:31:28.639-07:00Hey thanks for the question. There is a picture o...Hey thanks for the question. There is a picture of the plans laid out on a piece of Dollar Tree foamboard here: http://electricrcaircraftguru.blogspot.com/2013/02/building-flitetest-nutball-swappable.html<br /><br />As you can see, part of it just hangs off of the foam. That is where I make my elevator hinge. I just make the excess (minus the little tips) the elevator. I hot glue the little tips on to the main part of the plane. As for the lines not matching; I'm not sure. Make sure to print it "Actual Size," and you'll need to cut off an edge or two of each sheet of paper in order to overlay it onto the edge of the next piece of paper in the plans, and carefully tape it all together to make one large plan. Could take an hr. or so, and you just have to be very careful.Gabriel Stapleshttps://www.blogger.com/profile/10071071884455787806noreply@blogger.comtag:blogger.com,1999:blog-5854741938955568545.post-23010151775857355372013-03-16T17:23:53.672-07:002013-03-16T17:23:53.672-07:00Nice site and very informative. I am new at flying...Nice site and very informative. I am new at flying rc and would like to build a 24" nut ball. How is the part of the second dollar tree foam board attached to make a full 24"? <br /><br />Also when I tried to print off the plans for the 24" there was lines that did not match. What have I not got right?<br />Thanks for all your time and effort.<br />call sign Lazair 2Anonymousnoreply@blogger.com